Details

GTO / Linear PRO Swing Gate Opener Kit, Includes Battery Backup, Transmitter, Receiver, Battery Charger (500lb / 16ft) - PRO-SW2000XLS

The GTO / Linear Pro Swing Gate Opener Kit has a new and improved motor design which makes this opener ideal for today's single family homes or ranches. It features a larger, higher powered, lower RPM motor, improved front mount and scraper seal design, and open / close times between 15 and 20 seconds. This UL Rated Kit works on all types of gates, comes with a worry-free 2 Year Warranty and free shipping.

Kit Includes:

• Primary Operator Arm
• AC Transformer
• Receiver Antenna
• Entry Transmitter
• Battery Backup
• Mounting Hardware for a Post Mounted Installation
• 2 Year Manufacturer's Warranty (Residential Only)

Features:

• Open / Close Time: 15-20 Seconds
• Full systems capable, control board includes an adjustable obstruction sensing, gate sequencing and auto close settings
• Larger, Higher Powered, Lower RPM Motor
• Includes battery backup, 318 MHz RF radio receiver, entry transmitter, AC transformer and all necessary mounting hardware for a post-mounted installation, 15'' (38 cm) total offset.
• Controller With Jog Button Technology
• Improved Front Mount and Scraper Seal Design
• Low Voltage System - no electrician or welding required
• Solar Compatible, SW-2000XLS is fully compatible, and easily convertable to Solar Powered
• Features GTO / Linear Pro's Improved true soft start and stop operation
• Extended Cycle Life - New Improved motor design makes this opener ideal for today's single family homes or ranches
• U.L. rated for Class I. System certified to be in compliance with U.L. 325, latest revision
• For a Dual Gate Application the PRO-SW4200XL (2nd Gate Opener Arm) should be used with the PRO-SW4000XL to automate both gate leaves
• Works on all types of gates;* chain link, tube, panel, ornamental, wood and vinyl
• 2-Year Manufacturer's Warranty Included

Electrical Features:

• 12 Volt DC / 7.0 amp hour, sealed, rechargeable battery (included). Battery charge is maintained by a 120V AC/60 Hz input, 14V AC, 28 VA. output, transformer rectified to 14V DC through control board
• Powered by a reliable 12 Volt (120 Watt) DC motor, 16:1 planetary gear drive system
• Charging regulated circuit on control board. “Sleep draw” is 15 mA; “active draw” is 2 to 5 amps

Mechanical Features:

• The control board can be programmed for pull-to-open or push-to-open
• Operating temp -5 F (-21C) to +160 F (71 C)
• Range of arm stroke: up to 15'' (33 cm)
• Operator length: with arm fully retracted is 33.75"" (85.2 cm), mounting point to mounting point
• Operation, diagnostic and safety alarms
• Inherent obstruction sensing
• Soft start/soft stop for long mechanical life expectancy
• Auto close adjustable 3 to 120-second delay

*NOTE: Solid gates create wind resistance and can affect the performance of the entire gate system. Call technical service for the best advice for your application.